cargooreo.blogg.se - Displaycal

low contrast in SW-C line due to cheap panels with bad uniformity + agressive uniformity compnesation (cannot be turned off AFAIK) My guess is that this result is a sum of several factors: There is something very wrong with your setup. PS: I've posted my questions on the Displa圜AL Forum, but my post has been marked as in need of moderation and remains invisible. Thank you in advance for your thoughts and time. My Monitor (16-235) and Resolve are BOTH set to video-levels.

The final LUT should be loaded onto my BM Mini Converter SDI to HDMI 6G, but for the sake of testing and calibrating, I’m currently loading the LUT into Resolve through the project settings.

After a short profiling there shouldn’t be any demand for a higher delay since my measurements aren’t higher than 0.5 DE average and 5 DE peak.

What I learned so far and took out of the equation: Color-Gamut: rec709 (could also be set to: Adobe RGB, sRGB, DCI-P3) Brightness: adjusted in the calibration process Color-temp.: User (RGB bars adjusted in the calibration process)

My Monitor is set to the following settings - are they correct?.

Are my settings in Displa圜AL correct (see screenshots)?.

I went for the „BenQ SW270C by 4KM (i1 Pro).ccss“ which does not match my calibration device, but gave me best results after all.

I use a „xrite colorchecker display plus“, my system profiler calls it a „i1Displa圓“. Which Spectral Correction suits my monitor best.Although I read a lot about the calibration process, I’ve several questions and I’m just not sure, weather my Display is calibrated right: So far my results are ok-ish and the validation usually gives reasonable DEs. The monitor is connected via a BM Ultrastudio Monitor 3G (Thunderbolt to HDMI) to my Macbook. So I’m trying to calibrate my BenQ SW270C with Displa圜AL and the described „3D LUT creation workflow for Resolve“.